The new pump shed nearly complete!

A bit of painting to do and we’ll sort a garden around it, but the pump shed is almost done, and most importantly – we have water!

IMG_0306 

17mm treated ply bolted to the old steel tank tower frame. Was a bugger cutting ply to skewed trapezoid shapes! Should be nice and solid. Just the edge strips and door left to do.

IMG_0310 IMG_0307

Here’s the new pump and filter. The white cylinder is a 20 micron particulate filter I added to remove most of the sediment. The Aquifer is still a little dirty and if the sediment gets to the house it ruins the ceramics and fittings.

IMG_0315

The new system is high pressure (we had low) but when connected, a number of joints leaked (below ground too…). They couldn’t handle the load  😉 So there’s been a good number of small leaks we’ve needed to fix.

IMG_0316

The end result though is that we now have a 13,650 litre storage tank and high pressure house supply with awesome tap and shower pressure!

A few loose ends to tidy but should be all finished by next week!

Comments are closed.